WTT: LS1 Drive Shaft, HID's, RK Sport SS Hood, Spare Stock Parts
04-21-2009, 10:09 PM
#1
12 Second Club
Thread Starter
iTrader: (10)
Join Date: Nov 2007
Location: Tucson, AZ
Posts: 1,094
Likes: 0
Received 0 Likes
on
0 Posts
WTT: LS1 Drive Shaft, HID's, RK Sport SS Hood, 4.10's Ok I bought a 95 Z28 and I am going through what was done and what was not done still. At this point there are some things I would like to change out.
1) RK Sport SS Hood (Better pic tomorrow sorry its getting late)
I would like to trade for a Stinger Hood. Maybe a Cowl Hood, not sure yet let me know.
2) LS1 Alum. Driveshaft. Works great was keeping as a spare. 100.00
3) HID Kit fits the newer Camaro Headlights, I don't know a lot about HID Kits sorry it was part of another trade. I know they work and everything is there. They were on a 98 Z28. 90.00
--8000K HID's fit the low beam in the LSX f-bodys or any other car with 9006's.
4) 4.10 Series 3 Carrier Gears for a 10 Bolt. I was told low miles when I bought them and they look GREAT. I sold my other set this set I was going to keep but after driving around with the 3.73's I am going to keep those. 140
I have a stock alt and waterpump less than 2000 miles and the bracket they attach too if needed.
Also a Brand New LT1 Clutch with Pressure Plate, Throwout Bearing, all ready to go.
I would like to trade for:
52MM TB
Ported LT1 Intake Manifold
Ported or other Heads
Maybe a Cold Air Intake since this has the stock one
Electric Water Pump
Let me know! Thanks
1) RK Sport SS Hood (Better pic tomorrow sorry its getting late)
I would like to trade for a Stinger Hood. Maybe a Cowl Hood, not sure yet let me know.
2) LS1 Alum. Driveshaft. Works great was keeping as a spare. 100.00
3) HID Kit fits the newer Camaro Headlights, I don't know a lot about HID Kits sorry it was part of another trade. I know they work and everything is there. They were on a 98 Z28. 90.00
--8000K HID's fit the low beam in the LSX f-bodys or any other car with 9006's.
4) 4.10 Series 3 Carrier Gears for a 10 Bolt. I was told low miles when I bought them and they look GREAT. I sold my other set this set I was going to keep but after driving around with the 3.73's I am going to keep those. 140
I have a stock alt and waterpump less than 2000 miles and the bracket they attach too if needed.
Also a Brand New LT1 Clutch with Pressure Plate, Throwout Bearing, all ready to go.
I would like to trade for:
52MM TB
Ported LT1 Intake Manifold
Ported or other Heads
Maybe a Cold Air Intake since this has the stock one
Electric Water Pump
Let me know! Thanks
Last edited by Cross; 04-22-2009 at 12:45 PM.
