garage sale!
10-25-2009, 10:30 PM
#1
garage sale! got in a trade for some other parts and do not need.
For 3-series carrier, GM 7.5" 10-bolt rear end
should fit camaro, firebird, s10, etc....
dont know if the bearings are the correct size for earlier years , the kit was bought for a 98-02 style rearend.
motive gear, ratech install kit.
gears
220.00 SHIPPED.
here is a pic and detail description of the bearing kit.
i do not want to unbox the ring and pinion.
its in the dreaded foam box and i know it will fall apart and go everywhere.
parts are NIB, 1st time ive touched them.
pinion nut ring gear bolts shims marking compound and a total of 4 bearings. the pinion seal and crush sleeve is in a bag with its own bearing. im going to assume thats the pinion bearing.
bearing in clear wrapper with blue lettering is 2 1/2 inch.
the pair of bearings are are 2 3/4 and the pinion bearing is just over 3"
measurements were taken off the OD of the races.
------------------------------------------------------------------------
i used this for my th350 short tail(also fit powerglide) and my 9" setup.
ford racing aluminum driveshaft
yoke not included.
this is for the tube only.
$50.00
driveshaft has a few marks where something was rubbing, but nothiing mechanically wrong with the shaft, just needs ends.
measures 45.5" center of u joint to center of u joint.
this worked great for my setup. may differ depending on car and drivetrain placement.
For 3-series carrier, GM 7.5" 10-bolt rear end
should fit camaro, firebird, s10, etc....
dont know if the bearings are the correct size for earlier years , the kit was bought for a 98-02 style rearend.
motive gear, ratech install kit.
gears
220.00 SHIPPED.
here is a pic and detail description of the bearing kit.
i do not want to unbox the ring and pinion.
its in the dreaded foam box and i know it will fall apart and go everywhere.
parts are NIB, 1st time ive touched them.
pinion nut ring gear bolts shims marking compound and a total of 4 bearings. the pinion seal and crush sleeve is in a bag with its own bearing. im going to assume thats the pinion bearing.
bearing in clear wrapper with blue lettering is 2 1/2 inch.
the pair of bearings are are 2 3/4 and the pinion bearing is just over 3"
measurements were taken off the OD of the races.
------------------------------------------------------------------------
i used this for my th350 short tail(also fit powerglide) and my 9" setup.
ford racing aluminum driveshaft
yoke not included.
this is for the tube only.
$50.00
driveshaft has a few marks where something was rubbing, but nothiing mechanically wrong with the shaft, just needs ends.
measures 45.5" center of u joint to center of u joint.
this worked great for my setup. may differ depending on car and drivetrain placement.
