GMPP dual valve springs for LT1, up to .560 lift
#1
TECH Regular
Thread Starter
iTrader: (6)
Join Date: Nov 2005
Location: Wauconda, Il
Posts: 460
Likes: 0
Received 0 Likes
on
0 Posts
GMPP dual valve springs for LT1, up to .560 lift
330585-these are the GMPP dual valve springs good for up to .560 lift i beleive. i got them from a guy who had them with a hotcam i think it was, then he stepped up to a bigger cam, and i intended to use them but i got an amazing deal on a cam that is too big to use these with. my loss is your gain.
also come with retainers matched....
330586
they have a few hundred miles on them and were only pulled off to upgrade like stated. 90 bucks shipped.
PM me or e-mail at matta27x@yahoo.com
here's some pics...
also come with retainers matched....
330586
they have a few hundred miles on them and were only pulled off to upgrade like stated. 90 bucks shipped.
PM me or e-mail at matta27x@yahoo.com
here's some pics...
#2
Teching In
Join Date: Oct 2005
Location: LOWER ALABAMA
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
00330585 Heavy Duty Valve Spring
This dual valve spring is recommended for competition camshafts with .560” maximum valve lift.
Technical Note: Spring pockets on V6/60º cylinder heads must be machined to fit this spring. Umbrella-type valve stem seals are recommended. Use with aluminum valve spring retainer P/N 00330586 and valve seal kit P/N 10132715.
Dual spring, 1.379” OD, 140# @1.75” presure at installed height, 1.15” solid height, 325 average rate of pounds per inch.
Spects on the springs,are this the ones?
This dual valve spring is recommended for competition camshafts with .560” maximum valve lift.
Technical Note: Spring pockets on V6/60º cylinder heads must be machined to fit this spring. Umbrella-type valve stem seals are recommended. Use with aluminum valve spring retainer P/N 00330586 and valve seal kit P/N 10132715.
Dual spring, 1.379” OD, 140# @1.75” presure at installed height, 1.15” solid height, 325 average rate of pounds per inch.
Spects on the springs,are this the ones?
#5
TECH Regular
Thread Starter
iTrader: (6)
Join Date: Nov 2005
Location: Wauconda, Il
Posts: 460
Likes: 0
Received 0 Likes
on
0 Posts
im sure they could fit most v8s with the proper retainers. best bet is to call GM or a performance shop/machine shop. i know for sure they work on LT1s, other than that, i cant tell ya.