built th350 500hp capicity
12-03-2007, 10:59 AM
#1
On The Tree
Thread Starter
iTrader: (28)
Join Date: Feb 2006
Location: Clifton Heights,Pa
Posts: 165
Likes: 0
Received 0 Likes
on
0 Posts
built th350 500hp capicity hey all i have a turbo hydra-matic 350 the is fresh meaning zero mile, this trans has a transgo shift kit in it and has a B&M 500HP rebuild kit in it, all new seals and bushings, the case has been zyglow for cracks non were found as well as having been deburred on the outside and removing some flashing on the inside of the case, the pump is good and has been pressure tested assuring the piston works properly , the same goes for the lower,reverse piston,the hard parts are all used and spec out as far as the clearances are concerned,all new pan and pump bolts are used on this transmission,the trans comes with a speedo which has a green gear on it and tailshaft, a torque converter is included, the converter has been test and has a 1500-1800 stall speed depending on application, the converter size is 12 inches, the tests has been dyno'd and tested good, the case hase been painted silver with heat paint as well as the pan, the shift slector and vent have been paint also some spots were missed, the inside of the bellhouseing and pump have also been painted,a new vacuum modulator, i abj. with a vacuum pump but fine tuning will have to be done on car. this trans is out of a 1969-1976 pontiac but will fit any chevrolet, or bop ,there are some casing numbers first bellhousing c3, tail shaft 149, pan rail 41c100495, side of bell housing 6260110, cfd 3 ,26-l-j, this will fit any gm car or truck, this trans was built for a street car and will shift nice when you want and firm when you have the gas mashed or makes great for moderate towing ,makes a great gift for the holidays must go
