LT1 K&N, Turbo, misc.
#1
LT1 K&N, Turbo, misc.
plenum for lt1 fbody k&n, came on a car i bought
was not installed, has been smoothed/sanded down some
no filter,hoses, or clamps
60$ shipped
ok, then 50$ shipped
holset h1e turbo, 22cm cast into turbine housing, t4 flange
spins freeley, very slight shaft play,
semi polished compressor housing
supposed to be equivalent of a t60 type turbo,
3 in. turbine outlet
more than likely needs rebuild, would b good candidate for remote mount
setup, supposed to be able to support over 500bhp
175$+ship
-will take 200$ shipped for turbo-
lt1 front acc., bracket 45$ shipped
lt1 power steering pump/pulley/reserve 75$ shipped
lt1 maf no screen, 96 model 55$ shipped
will post pics and more stuff later
-obo on the other stuff-
was not installed, has been smoothed/sanded down some
no filter,hoses, or clamps
60$ shipped
ok, then 50$ shipped
holset h1e turbo, 22cm cast into turbine housing, t4 flange
spins freeley, very slight shaft play,
semi polished compressor housing
supposed to be equivalent of a t60 type turbo,
3 in. turbine outlet
more than likely needs rebuild, would b good candidate for remote mount
setup, supposed to be able to support over 500bhp
175$+ship
-will take 200$ shipped for turbo-
lt1 front acc., bracket 45$ shipped
lt1 power steering pump/pulley/reserve 75$ shipped
lt1 maf no screen, 96 model 55$ shipped
will post pics and more stuff later
-obo on the other stuff-
Last edited by NemeSS; 04-10-2008 at 10:18 PM.
#2
pics of turbo
these are pics of turbine,side
compressor side
and k&N plenum, no hoses, clamps, filter
plenum only
h1e turbo is used in budget turbo builds,
needs remote wastegate, these size turbo does come with internal wg
like other stock turbos
came of turbo diesel motor
compressor side
and k&N plenum, no hoses, clamps, filter
plenum only
h1e turbo is used in budget turbo builds,
needs remote wastegate, these size turbo does come with internal wg
like other stock turbos
came of turbo diesel motor
Last edited by NemeSS; 07-11-2011 at 12:43 PM.