Blu Streak.....
#1
Thread Starter
10 Second Club
iTrader: (8)
Joined: Nov 2001
Posts: 10,023
Likes: 6
From: LT1 land...the "409" of the 90s!
Blu Streak.....
..In Monroe tonight. There seemed to be a presance on my road tonight. Not sure what it was but it was Blue Looked like a gumball rally. I was watching from my Locked up Garage
Thanks for coming out and Helping tonight Mark! We got some elecrtical Gremlin's found and killed. Bottom of the car is all bottoned up save for the O2 bung cap falling out just before all the activity's
Now we just need to wire the Interior switchs, Swap out the seats and wire the Wide band
Thanks for coming out and Helping tonight Mark! We got some elecrtical Gremlin's found and killed. Bottom of the car is all bottoned up save for the O2 bung cap falling out just before all the activity's
Now we just need to wire the Interior switchs, Swap out the seats and wire the Wide band
#3
Cool, 'bout damn time Ellis! Too bad you don't have NOZ on it. All the fast cars have NOZ ya know.....
And as always, it was my pleasure to help you out, for what little I did.
I'll be busy at the dyno tonight, but I can come back out Wed nite if you need me.
And as always, it was my pleasure to help you out, for what little I did.
I'll be busy at the dyno tonight, but I can come back out Wed nite if you need me.
Trending Topics
#8
Originally Posted by TwoFast4Lv
Thanks Guys/ going to try and wrap most of it up tonight
Everyone else must bo to afraid to post No problems for the slow cars
Everyone else must bo to afraid to post No problems for the slow cars
Maybe I should have picked some things up?
#10
Thread Starter
10 Second Club
iTrader: (8)
Joined: Nov 2001
Posts: 10,023
Likes: 6
From: LT1 land...the "409" of the 90s!
Well she is all wired save for the heater in the rear. Need to find a good Tach signal for a LT1 as the WBC won't rear the negative side of the coil so no RPM readings
Other then that she just needs the toe setup and the panels reinstalled!
Other then that she just needs the toe setup and the panels reinstalled!
#11
Cut the inductive pick-up off your timing light, clamp it on #1 & wire that bitch up.
Sounds like your getting there Ellis. Can't wait to see that thing run Friday.
PS let me know if you need to trailer it down for the alignment
Sounds like your getting there Ellis. Can't wait to see that thing run Friday.
PS let me know if you need to trailer it down for the alignment
#12
Try this....
Tach signal is white wire from pin # 13 on connector #1 on the PCM. "Connector #1 maybe the black connector, can’t be sure about that without book in front of me…."
Tach signal is white wire from pin # 13 on connector #1 on the PCM. "Connector #1 maybe the black connector, can’t be sure about that without book in front of me…."