Sub-frame at front of LCA bracket BENT!
Sub-frame at front of LCA bracket BENT! The subframe of the Unibody at the front mount of the LCA on both sides bent… due to the floor pan being roached. Cut out a fair bit, but it's looking like it's going to be a job and I don't know jack about this stuff.
So I'm coming to the mountain…
Men of the Body section: WTF? Any ideas?
So I'm coming to the mountain…
Men of the Body section: WTF? Any ideas?
Last edited by OVA1; Nov 15, 2013 at 09:46 AM.
That car is all sorts of rusted. Abandon the chassis and transfer parts to a newer roller and cut your losses. The rear seats section is almost rusted out too.
If you have to save it I would just cut the floor pans out of a donor car
If you have to save it I would just cut the floor pans out of a donor car
Trending Topics
But thanks for the advice. Can't say I disagree, I was just hoping someone had seen it and fixed it.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
