Pulling Dent from rocker (pic)
Thread Starter
Teching In
Joined: Apr 2014
Posts: 46
Likes: 0
Pulling Dent from rocker (pic) My buddies got a 4th gen camaro. He bought it with the dent in rocker panel, previous owner took it over a curb in his driveway.
I used to work as a detailer for a body shop out of high school and remember the techs using stud welder and slide hammer to pull **** like this out. Is there another way we can pull this off without a shelling out over $200 for a stud gun?
I used to work as a detailer for a body shop out of high school and remember the techs using stud welder and slide hammer to pull **** like this out. Is there another way we can pull this off without a shelling out over $200 for a stud gun?
My buddies got a 4th gen camaro. He bought it with the dent in rocker panel, previous owner took it over a curb in his driveway.
I used to work as a detailer for a body shop out of high school and remember the techs using stud welder and slide hammer to pull **** like this out. Is there another way we can pull this off without a shelling out over $200 for a stud gun?
I used to work as a detailer for a body shop out of high school and remember the techs using stud welder and slide hammer to pull **** like this out. Is there another way we can pull this off without a shelling out over $200 for a stud gun?
if you have a welder you could weld some studs on and use a slide hammer.
Staging Lane
Joined: Jan 2015
Posts: 66
Likes: 0
From: NC
As said above studs, or weld a metal tab following the deepest part of the crease, both of which will need a slide hammer to pull the dent out. Then there's the less preferred old school way with screws which leave holes to deal with.
