**LOOK** Lots of good stuff *parts added 4-5-10*
12-11-2009, 03:12 PM
#1
**LOOK** Lots of good stuff *parts added 3-30-11* Category: Racing Parts
Price: $1
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird, Corvette
Location (State): AL
Item Condition: Used
Shipping Information: Item Can be Shipped
LS Engine?: Fits LS Engine
Black 4 inch 45* rubber hose coupler 3 of them NEW $10 each
Thermo Tec starter heat shield kit part#14150, NEW $10
LT1 rear main seal adapter $10
GM factory service manual for 1996 F-Car Camaro-Firebird, book 1 of two, Driveability and emissions, trans diagnosis, electrical diagnosis $20
Milodon oil pump primer tool,For small block Chevy part#23000, NEW $20
Homemade panhard bar relocator,93-2002 F body, for big single ex(4 inch) or true duals over the axle. This is not junk it is very well made. I ran it on my car for 4000 miles. Made by cutting and extending the factory brace using 2 braces. Looks factory. Does the same thing the $200 Spohn and BMR ones do for 1/2 the price.Requires adjustable panhard rod. $75
2 Brand new tires, 205-50-17 Kuhmo Ecsta Supra, never mounted $70
LS1 Corvette Exhaust manifolds $40
LT1 oil fill cap with standoff that screws in valvecover $5
Drivers airbag out of 94 Z28 $20
Passenger airbag out of 94 Z28 $20
Lt1 oil pan rails $10
1 oxygen sensor harness extender, 4 pin flat connector,new, 2ft long $15
LT1 Corvette oil pan $30
Stock rear springs out of a 94 Z28 $20
3.5 inch mandrel 90* exhaust bends, long radius new one $20, used one $10
Energy Suspension urethane trans mount, new in box $15
MSD Part# 8513 dummy distributor for you single plane guys, so you dont havee to run the factory oil pump drive Brand new $115
Added 3-10
98-02 Trans Am foglight housings, bulb in one only, one has a small scratch. $50
ADDED 3-22
Probe forged pistons Part# 13724 030 small dome new in box $380
Probe forged pistons Part# 12336 030 flat top new in box $365
Probe I beam 5.7 rods Part# 10067 4340 forged with the shorter head ARP bolts for stroker clearance New in box $355(new bolts were $90)
CV Protorque starter for small Chevy used $75
Crower solid roller lifters part#66290 new in box$390
Added 4-5-10
Probe/scat 4340 forged 3.750 stroke crank, knife edged.One piece rear main seal, Brand new $450
Spohn lower control arms and Packard bar, poly on both ends, all double adjustable. Almost new, less than 5000 miles$ 195
Hawk dtc30 brake pads for the front of a ls1 f body, 1 event, over half pad left. Work great on the street. $65
I need this stuff gone, I priced this stuff reasonably, or so I think I did.
PRICES DO NOT INCLUDE SHIPPING
Paypal, add the fee:
Speedadikk@comcast.net
Thanks for looking.
Last edited by FASTFATBOY; 03-30-2011 at 10:46 AM.
01-11-2010, 12:21 PM
#6
TECH Fanatic
iTrader: (21)
Join Date: Oct 2004
Location: San jose, CA
Posts: 1,435
Likes: 0
Received 0 Likes
on
0 Posts
Coldfusion standalone fuel system for 4th gen F body(93-2002 Camaro-Firebird), mounts in left front of engine bay 1 gallon. Comes with braided lines, Holley blue fuel pump, regulator(with gauge), relays, switches etc.ALmost brand new PRICE $400 DOnt let the low pressure deal scare you, you can re jet any NOS system.
Pictures????
Pictures????
Trending Topics
02-21-2010, 09:31 AM
#13
More parts added, more to come.
Here are pics of the panhard relocator, has all the parts, you will need one bolt to make it work. Also requires an adjustable panhard rod. Look on the weight bench for all the parts that go with it. It is made so your factory heat shield will hook up right to it....... It worked REALLY well.
[IMG]
[/IMG]
Here are pics of the panhard relocator, has all the parts, you will need one bolt to make it work. Also requires an adjustable panhard rod. Look on the weight bench for all the parts that go with it. It is made so your factory heat shield will hook up right to it....... It worked REALLY well.
[IMG]
[/IMG] 
