Sheetmetal elbow and Monoblade for single plane.
#1
Sheetmetal elbow and Monoblade for single plane.
I am moving to a 4 hole setup with a hat.
This is a Intake elbows .com sheetmetal elbow with a AS&M billet Monoblade 1300 cfm throttlebody.
This setup MIGHT fit inder a stock hood, I have a very low WS6 style ram air hood(see sig) it fits under with no mods, cowl is slightly trimmed under the hood seal, it is on a super victor, on a vic jr I know it would fit under a stock hood. Its setup to work with a stock throttle cable, I made and welded an adjustable deal on the side of it.
I sent this elbow back to Aaron where it was made and had a short side radius plate put in it, they dont come with one. This helps the air turn into the plenum. Also has been drilled on the rear of the elbow for all the stock intake vacuum fittings to screw in.
Both these parts have 8500 miles.
$500 shipped for both.
This is a Intake elbows .com sheetmetal elbow with a AS&M billet Monoblade 1300 cfm throttlebody.
This setup MIGHT fit inder a stock hood, I have a very low WS6 style ram air hood(see sig) it fits under with no mods, cowl is slightly trimmed under the hood seal, it is on a super victor, on a vic jr I know it would fit under a stock hood. Its setup to work with a stock throttle cable, I made and welded an adjustable deal on the side of it.
I sent this elbow back to Aaron where it was made and had a short side radius plate put in it, they dont come with one. This helps the air turn into the plenum. Also has been drilled on the rear of the elbow for all the stock intake vacuum fittings to screw in.
Both these parts have 8500 miles.
$500 shipped for both.