Lt1 Turbo motor, DFI, Turbo system FOR SALE
02-22-2010, 01:35 PM
#1
On The Tree
Thread Starter
Join Date: Dec 2005
Posts: 125
Likes: 0
Received 0 Likes
on
0 Posts
Lt1 Turbo motor, DFI, Turbo system FOR SALE Category: Engine - Complete Motors
Price: $8999
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird, Corvette, 67-92 Chevrolet Camaro, 67-92 Pontiac Firebird
Location (State): TX
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LT1/LT4
Motor consist of:
* Lt1 block...4bolt splayed Billet main caps
* Cola Crank (355ci)
* Eagle H-beam rods
* Custom Je Pistons
* Turbo People spec'ed Solid Roller (Specs provided to buyer..had to cam
doctor it to get them)
* Extreme Duty Timing Chain
* 2 Piece SBC Timing Cover..Modded to work with Lt1
* ATI Super Damper Balancer for Lt1
Heads/Valvetrain
* AFR Raised Runner 215 Cylinder Heads with Spread Port Exhaust, cast with Lt1 coolant passages..very few sets of these where done. Custom porting by Craig at GTP...flow in the range of 340-350cfm @ .650. Custom valves and seats for turbo motor..all setup by Craig. These heads alone cost ~6k.
* Jesel Shaft Rockers and offset solid roller lifters speced for these heads
* Sheetmetal Valve Covers
Induction
* Super Victor 4500 for AFR 215RR Heads, fully ported and matched to heads. Custom intake elbow with AS&M monoblade throttle body.
Ignition/Computer
* Accell Dual Sync dist with harness for Gen 7 DFI
* Gen 7 Dfi with harness, pre programed by Job Spetter
Turbo System.
* Custom built tig welded/argon backpurged headers that go above/between valve cover and shock tower on a 4th Gen Camaro. This allows for clearance of a 4inch downpipe with modifyed stock motor mounts. 51mm Innovative Indygate. System is setup for a t4 turbo, but can be modifyed for a t6 turbo with a new crossover pipe. Was built with a PTE88 as mockup. Complete turbo system coated by performance coating in arlington texas in Grey Titanium.
All that you would need to put this in your car and make 1000+rwhp is a fuel system, injectors, fuel rails, and an ignition box of your choice. I am looking to get $8999 or best offer for everything mentioned. I have alot of spair parts that will be included like Turbosmart Race BOV, oilpan, melings oil pump, waterpump plates with -12 or -16 fittings of your choice, ect. More pictures apon request...email me with any questions you might have.
Cmarsh93z@charter.net
