FS: MTI Carbon Fiber Air Lid
#1
Launching!
Thread Starter
iTrader: (20)
Join Date: Aug 2005
Location: Allendale, Michigan
Posts: 276
Likes: 0
Received 0 Likes
on
0 Posts
![](https://ls1tech.com/forums/images/ranks/ls1tech10year.png)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Category: Engine - Intake/Fuel
Price: $85
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird
Location (State): MI
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LS1/LS6
Condition:All in all it looks awesome when installed. As with most MTI lids, the piece on the back half started to come loose so I glued it and black siliconed it up, it looks just fine when it is installed, and doesn't hurt function at all. Also, I have an Mifbody sticker over the top half of the lid where the previous owner's hood must has scraped it a bit, its not bad though, to give you an idea of the scuff area, on one side its like 1/4 inch by 1 inch, and then on the other side its like 1/4 inch by 1/2 inch.. Both logos are stickers that you could remove. Also, one back tab also chipped off a bit but there was enough left that it still slid in and wasn't noticeable when I had the lid installed. If any of you have seen the car in person you can vouch for how this lid looked, my car doesn't even get dirty.. so the lid has been well maintained. Attached is a picture of the lid on my car to give you an idea.
SOLD
![The Patriot !!](https://ls1tech.com/forums/images/smilies/LS1Tech/gr_patriot.gif)
Last edited by redfbird99; 03-15-2010 at 06:02 PM.