chpmnsws6

iTrader: (70)

Category: Accessories
Price: $250
Location (State): IL
Item Condition: Used
Shipping Information: Item Can be Shipped

I have some heads sitting here from my engine that I will not be using on my little 5.3 Miata build. They are ported 241's, but I do not know who ported them. They do not have flow numbers, but they look very even port to port and worked well on my last engine. The machine shop said the heads need the valve guides knurled and cut since I had the incorrect valve angles on it for 800 miles or so. They are milled .040 for added compression and were on my 347 build in my C5 before it was totaled .

200 shipped within the 48 states takes them. For under 300 you can have a set of ported heads if you know any machining guys!

Also available-
Trick Flow 7.350 pushrods. They were in the same 800 mile old engine, and were not needed for my 5.3 build.

90 shipped within the 48 states takes these also.

Sorry about the pictures of the heads. Its the best I could get with this camera.

If you buy them both, its 250 shipped within the 48 states. These pushrods were supposed to be the ones to put the valve at the correct angle.

chpmnsws6

iTrader: (70)

Up!!!

96RamAirTA

iTrader: (6)

so 250 shipped to 76504?

chpmnsws6

iTrader: (70)

Works for me!

You have a PM

chpmnsws6

iTrader: (70)

Buyer seems to have backed out....... Or like the rest of us, his better half is the controller of the money.