408 longblock FS
#1
Thread Starter
TECH Apprentice
iTrader: (21)
Joined: Jun 2007
Posts: 317
Likes: 1
From: Texarkana, TX
408 longblock FS
Category: Engine - Complete Motors
Price: $6500
Location (State): TX
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LS2/LS3/LS7/L92/LS9, LS1/LS6
LS Engine?: Fits LS Engine
Started out with a Brand new Iron 6.0 block
Bored 30 over and torque plate honed.
Diamond 2cc flat top pistons with coated skirts
Callies compstar H beam rods with arp 2000 bolts
Callies Dragonslayer 4in crank
Arp main studs
File fit mahle piston rings setup for 250 hit of Nitrous
1st .025 2nd .029 specs from erik at HKE
Rollmaster double roller timing set..
Melling HV oil pump
SFI approved 25% under drive pully..
Arp oil pan bolt set..
Stock F body oil pan
Clevite bearings..
Topend
TEA Trickflow 235s fully setup by TEA 70cc, Flowed 350cfm at .600
Port matched Victor jr intake.
Trick flow 7.5 pushrods
.051 Cometic head Gasket set
Arp head studs
LS7 lifters With brand new drilled trays.
Custom Grind comp cam 251 254 @ .050 .623 .623 112+4 LSA
Arp cam bolts and retainer bolts.
11.5:1 comp
Every part in this engine was BRAND NEW
I took the rocker arms off to keep the pressure off the springs, And while they were off I sold them, So the only thing it needs is RRs..
I have no dyno numbers but I can tell you the car went 6.8s @ 104 in the 1/8mile N/A, Leaving in 2nd gear, 4L80e and 12 bolt, 3580lbs
Engine have never been sprayed and only has about 3K miles on it..
The engine is in a buddy of mines shop bagged up..
I also have a brand new set of morel HYD link bar lifters that ill let go for $450 More.
$6500 OBO