WTT/FS: Pump gas 406 sbc complete with BigStuff 3 and converter
12-30-2010, 06:09 PM
#1
On The Tree
Thread Starter
iTrader: (4)
Join Date: Nov 2009
Posts: 106
Likes: 0
Received 0 Likes
on
0 Posts
WTT/FS: Pump gas 406 sbc complete with BigStuff 3 and converter Category: Engine - Complete Motors
Price: $8250
Part Fits: 67-92 Chevrolet Camaro, 67-92 Pontiac Firebird
Location (State): IN
Item Condition: Used
Engine: Small Block
LS Engine?: Non-LS Part
406 sbc
509 block .030 over, block is not filled
Eagle crank
Eagle H-beam rods
SRP flat top pistons
ATI dampner
AFR 210 (non-eliminator) heads ported by Port Pros in TX flow just under 300 @ .650
2.05/1.60 Ferrea valves
Titanium retainers
Jesel shaft mount rockers
compression is 10.6:1
Bowtie valve covers
Custom CamMotion solid roller camshaft
Accel ProRam intake port matched to heads
WILSON TB 1136 CFM
WILSON 100 DEGREE INTAKE ELBOW
1/2 inch fuel rails
55 LPH INJECTORS
WILSON NITROUS SPRAY BARS MACHINED INTO ELBOW
Custom n2o PTC torque converter w/ anti-ballon plate matched to cam.
Big Stuff 3 injection. Tuned by Larry @ ASSC
Ran a best of 10.92 on motor in a 3600 lb car that was geared for n2o and had the n2o converter. Easy 10.5x in a lighter car or in a heavy car setup for motor.
Drop it in, wire it up and you have a mid 10 second car on hp and can spray 275 into it.
$8250 for all of it. Price is FIRM
Will consider partial or complete trade for an LS based motor.
Last edited by flyin; 12-30-2010 at 06:40 PM.
