Procharger bracket, custom inlet hat, fan kit, HI-6 ign, coils, wires FS
04-06-2011, 09:59 AM
#1
Procharger bracket, custom inlet hat, fan kit, HI-6 ign, coils, wires FS Category: Engine - Electrical
Price: $0
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird
Location (State): FL
Item Condition: Brand New
Shipping Information: Item Can be Shipped
Engine: LT1/LT4
LS Engine?: Non-LS Part
Sold w/out inlet hat shown. 4" 90* elbow from Epp and 9" length 4" K&N filter. You will have to get your 4" coupler to connect the inlet hat to inlet side of blower. Industrial strength 4" tubing withstands over 180lb of crush weight so you don't have to worry about it collasping under boost. Seen over 700rwhp w/ this setup. If using aftermarket K-member it will fit perfect, if stock you'll need to extend. Shown mounted below. Asking 85.00 shipped SOLD
Crane PS91 coil. Used w/ less than 1K. Asking 35.00 shipped
Crane PS91 NIB used only to diagnose. Asking 45.00 shipped
Crane HI-6 igniton w/ built in rev limiter. Less than 1K miles. Still on car but can have ready. Comes w/ harness and instruction manual. Asking 155.00 shipped OBO
Paypal accepted.
Last edited by SRZ; 04-14-2011 at 09:49 AM.
