BadgeZ28

iTrader: (28)

Category: Engine - Power Adders
Price: $250
Location (State): OR
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LS1/LS6
LS Engine?: Fits LS Engine

Crank pulley fits fourth Generation F-body stock balancers. Overall diameter is 8 1/8". Supercharger pulley has "86" written on it and appears to be a 3.86" unit. Shaft diameter is approximately 7/8" Both are in very good condition.
$250.00

MadIceV8

iTrader: (12)

Have never seen a company make a crank pulley like this for LS1 motors. Not exactly interested since I have a SDCE setup but I am intrigued. Any more picture's?

BadgeZ28

iTrader: (28)

I hadn't seen one either. I will take more pictures.

BadgeZ28

iTrader: (28)

here is a front view shot
http://i17.photobucket.com/albums/b65/Badge01/001.jpg

MadIceV8

iTrader: (12)

Impressive that it looks to also be one solid piece. SDCE has one similar but is a 2-piece design. Also this looks stronger since it matches the hub. Diameter is quite large though, which is good but may be an issue with the water pump?

BadgeZ28

iTrader: (28)

I bought it to go from 6 rib to 8. I then got a single tubo kit so the supercharger stuff needs a new home. When I took off the procharger 6 rib pulley I pushed this one up into place and it slid right in.

BadgeZ28

iTrader: (28)

Sunday bump