Built 8.8 Set up for f-body Price Dropped!!!
07-24-2011, 08:55 PM
#41
Staging Lane
Thread Starter
iTrader: (4)
Join Date: Nov 2006
Location: Plano, TX
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
Category: Steering & Suspension
Price: $825
Location (State): TX
Item Condition: Brand New
LS Engine?: Fits LS Engine
I believe it is 2 inches per side, not my axle but thats what the stock mustang length ends up being. Can't believe this hasn't sold yet, 2 inches narrower on each side just means you would need 15x10 wheels with a 5.5 backspacing instead of 7.5 backspacing. And 5.5 backspacing is a LOT easier to find than 7.5, GLWS
-Will
-Will
07-26-2011, 12:35 AM
#43
You mentioned you were gonna use a mini ladder bar, but just curious, what kind of torque arm could be used for this or could a normal TA be used on this without all kinds of fabbing?
07-26-2011, 02:43 AM
#45
Staging Lane
Thread Starter
iTrader: (4)
Join Date: Nov 2006
Location: Plano, TX
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
Panhard bar, lca's, and spring perches are done all that is direct bolt in. You will need to fab something to bolt the tq arm to or make some mini ladder bars to hold the rear end in place so it doesn't flip forward.
08-02-2011, 01:52 AM
#52
Staging Lane
Thread Starter
iTrader: (4)
Join Date: Nov 2006
Location: Plano, TX
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
Maybe if I break down what I have in this someone will pick it up lol..
Motive 3.90 gears 229.99
Motive install kit + new bearings 74.99
31 spline Ford racing track loc with carbon discs 224.99
Strange 31spline axles 299.99
10 bolt donor rear end ?
8.8 rear end 75
Welding + setting up the rear end labor 575
Est. Total without taxes and shipping 1,479.96
Motive 3.90 gears 229.99
Motive install kit + new bearings 74.99
31 spline Ford racing track loc with carbon discs 224.99
Strange 31spline axles 299.99
10 bolt donor rear end ?
8.8 rear end 75
Welding + setting up the rear end labor 575
Est. Total without taxes and shipping 1,479.96
08-05-2011, 01:53 AM
#56
i'll give you $700.00 shipped to 53105 and i'll figure out the fab work on the tq arm
email me at dan_hanson70@yahoo.com
email me at dan_hanson70@yahoo.com
11-04-2011, 01:29 PM
#58
quick question.. ive been searching just havent found an exact answer yet. you had this one out of a 96 mustang gt i take it? is it just the factory length out of the mustang that you put brackets onto? or did you shorten it?
