AFR 216 runner AFR heads LT1 LT4
#1
AFR 216 runner AFR heads LT1 LT4
Category: Engine - Intake/Fuel
Price: $1450
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird, Corvette
Location (State): AR
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LT1/LT4
LS Engine?: Non-LS Part
These heads have abour 100 miles on them and 6-8 dyno pulls on my engine.
ONLY reason I am selling it going with a different engine setup. These heads are ready to bolt up and go.
Asking 1450 Shipped to your door, these gotta go, so price is cheap.
Serious offers only
Thanks Ben
Here was the engine
#2
found out I will need a different exhaust valve, so the buyer will receive these heads bare, BUT with valvs, just add your head hardware like valvesprings, rockers studs, rocker arms (use of your existing heads if you want to go that route, this is what I mean by hardware)
These same heads from AFR bare that flow 30 CFM less on the intake/exhaust will cost around 2000
I don't care to lose a little since I want to mess with a new project
Here is the flow numbers from Lloyd Elliot
The intake has a 58/45/33 valve job and the exhaust is a radius type valve job.
.2 136/105
.3 191/139
.4 241/173
.5 271/198
.6 289/214
.650 294/219
These were on Lloyds conservative bench, exhaust flow is without a pipe, he mentioned they would be around 236 with pipe
These same heads from AFR bare that flow 30 CFM less on the intake/exhaust will cost around 2000
I don't care to lose a little since I want to mess with a new project
Here is the flow numbers from Lloyd Elliot
The intake has a 58/45/33 valve job and the exhaust is a radius type valve job.
.2 136/105
.3 191/139
.4 241/173
.5 271/198
.6 289/214
.650 294/219
These were on Lloyds conservative bench, exhaust flow is without a pipe, he mentioned they would be around 236 with pipe
Last edited by T/A KID; 03-08-2012 at 06:45 PM.