806hp 435" LS7 Engine Masters Engine
#1
806hp 435" LS7 Engine Masters Engine
Category: Accessories
Price: $1
Location (State): GA
Item Condition: Used
LS Engine?: Fits LS Engine
435" Engine Master's Challenge engine. Was on front cover of February's Popular Hot Rodding magazine, and is getting an article in an upcoming Hot Rod Magazine. Does not come with efi components or throttle body. Engine made 806 hp @ 66-6700 rpm and 670 ft/lbs at 56-5700 rpm.
http://blogs.hotrod.com/eric-roycrof...14-144695.html
GM 6.0 block
Lunati pro series 4.185" crank (extensively modified)
Scat 6" rods
Diamond custom pistons (11.5-1 compression. Will run on pump gas)
Total seal .043" rings
King bearings
GM LS7 heads ported by Ultra Pro Machine, and then reworked and hand finished. Went 392cfm @ .800" lift before reworking. Never flowed afterward.
Manley Valves
Manley springs
Manley titanium retainers
Comp/ T&D shaft rockers
Comp billet core Camshaft
Comp short travel tie bar lifters (extensively modified)
Trend 3/8" .135" wall push rods
Cloyes timing set
Innovators west balancer
All pro intake (extensively modified)
Cometic head gaskets
All arp hardware
$11,000. No tire kickers! Don't pm me with bullshit please. Post any questions about details of engine in this thread.
Last edited by WE TODD DID; 11-03-2014 at 07:44 AM.