mustang swap fox body swap pieces and lq9
01-15-2009, 06:49 PM
#1
Registered User
Thread Starter
Join Date: Nov 2008
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
mustang swap fox body swap pieces and lq9 ALL FOR 79-93 FOX BODY MUSTANG
4inch cervinis bolt on cowl hood. $300
6.0L LQ9 with 32K miles from 03 escalade (accessories, harness, pcm, intake, manifolds etc). $1,000
Brand new flaming river manual rack with bumpsteer kit and offset rack bushings. Includes steel steering shaft for use on flaming river rack. $350
AJE tubular k member, this is the updated k member from AJE (see their website) this allows the use of windors,4.6s BBC,SBC LS any motor just have to use the appropriate engine mounts that they sell. I have the ones setup for BBC/SBC and LS motors. $300
D&D tubular lower control arms with sway bar mounts. $125
Lakewood 90/10 struts and 50/50 shocks $100 ALL
D&D coil over conversion kit with drag springs $125
Competition engineering 10 piont cage kit (not installed) Have extra gussets $180
Subframe connectors weld in, summit. $30
Lower torque box reinforcements. $20
8.8 rear end brace. $20
Baseline performance anti roll bar (just like wolfe piece) not installed. $125
GT4202 Brand new turbo T6 flanged (Garret Research). 850-1000hp capable. $650
AOD tranny, said to have been rebuilt but has about 20K on it and has been sitting in the garage for almost a year. $20
Most of a black interior (grey dash and center console/carpet still in the car). No carpet/door panels as I was building a drag car and was going to use one Kirkey seat and recover the existing grey door panels in black. $50
(3270 total)
Buy it all and get the whole car for free and save $500
Call if serious.
Dan 925-348-1534
4inch cervinis bolt on cowl hood. $300
6.0L LQ9 with 32K miles from 03 escalade (accessories, harness, pcm, intake, manifolds etc). $1,000
Brand new flaming river manual rack with bumpsteer kit and offset rack bushings. Includes steel steering shaft for use on flaming river rack. $350
AJE tubular k member, this is the updated k member from AJE (see their website) this allows the use of windors,4.6s BBC,SBC LS any motor just have to use the appropriate engine mounts that they sell. I have the ones setup for BBC/SBC and LS motors. $300
D&D tubular lower control arms with sway bar mounts. $125
Lakewood 90/10 struts and 50/50 shocks $100 ALL
D&D coil over conversion kit with drag springs $125
Competition engineering 10 piont cage kit (not installed) Have extra gussets $180
Subframe connectors weld in, summit. $30
Lower torque box reinforcements. $20
8.8 rear end brace. $20
Baseline performance anti roll bar (just like wolfe piece) not installed. $125
GT4202 Brand new turbo T6 flanged (Garret Research). 850-1000hp capable. $650
AOD tranny, said to have been rebuilt but has about 20K on it and has been sitting in the garage for almost a year. $20
Most of a black interior (grey dash and center console/carpet still in the car). No carpet/door panels as I was building a drag car and was going to use one Kirkey seat and recover the existing grey door panels in black. $50
(3270 total)
Buy it all and get the whole car for free and save $500
Call if serious.
Dan 925-348-1534
