Ideas/help adjusting my nitrous tune for NA
#1
12 Second Club
Thread Starter
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Hello - I have EFILive V2 and I'd like to install COS5 on my 02 LS1 and configure the nitrous monitor.
The mods on my car are listed here:
http://www.fquick.com/garages/Chevro...o_SS/2002/429/
I currently have my car tuned by MTI to run a 100 shot and it runs just fine with spray, but it's not overly impressive N/A.
I have attached my nitrous tune and I'd like to get some suggestions on how to modify this to be a strong N/A tune so I can then swap the spark and fuel tables from this tune with COS5 when the nitrous is enabled.
The car made 420 N/A and 520 Nitrous with a 100 shot. I'd like to see the N/A numbers in the 450 range if possible and then I'll swap to 150 jets for spray.
Several other cars that have close to my same setup have made 460 with a strong N/A only tune.
Any help is appreciated. Thanks!
The mods on my car are listed here:
http://www.fquick.com/garages/Chevro...o_SS/2002/429/
I currently have my car tuned by MTI to run a 100 shot and it runs just fine with spray, but it's not overly impressive N/A.
I have attached my nitrous tune and I'd like to get some suggestions on how to modify this to be a strong N/A tune so I can then swap the spark and fuel tables from this tune with COS5 when the nitrous is enabled.
The car made 420 N/A and 520 Nitrous with a 100 shot. I'd like to see the N/A numbers in the 450 range if possible and then I'll swap to 150 jets for spray.
Several other cars that have close to my same setup have made 460 with a strong N/A only tune.
Any help is appreciated. Thanks!
Last edited by jermstyle; 12-02-2008 at 12:20 PM.