low MAP performance SES.

Reply Subscribe

Thread Tools

Search this Thread

Oct 22, 2010 | 08:09 PM

pHEnomIC

Thread Starter

11 Second Club

iTrader: (14)

Joined: Nov 2004

Posts: 1,653

Likes: 1

From: Michigan (Macomb or Lansing)

low MAP performance SES.

I keep getting the SES for low MAP performance. I have a new h/c/i and i had to relocate the map to the front of the manifold because i have a fast 102.

Is there something going on or is this just engine characteristics causing it to fail?

I am getting 63kpa ish on idle and close to 100 on WOT, it seems like its working fine to me. Reads max when cars off.

I made sure my intake, tb, etc are tight and even tried sprayin starter fluid, no leaks it seems.

Oct 23, 2010 | 09:16 PM

pHEnomIC

Thread Starter

11 Second Club

iTrader: (14)

Joined: Nov 2004

Posts: 1,653

Likes: 1

From: Michigan (Macomb or Lansing)

Bump, p0106 btw

Oct 24, 2010 | 07:22 AM

BLK02WS6

9 Second Club

iTrader: (2)

Joined: Jul 2002

Posts: 2,583

Likes: 1

From: on the dyno tuning in MD

You probably need to work table C3003 Predicted MAP Max...

Oct 24, 2010 | 10:34 PM

DrkPhx

10 Second Club

iTrader: (15)

Joined: Nov 2001

Posts: 4,519

Likes: 0

From: St. Michael, MN.

Quote:

I am getting 63kpa ish on idle

P0106 is usually idle related. Double check the freeze frame data to make sure. As mentioned above you need the adjust (increase) the value in table C3003 specific to the idle region which is 800 rpm x 0 TPS %. The stock value is 62, so you need to increase that value higher than your actual idle kPa. Set it to 70 to make sure.

Reply Subscribe