can i pull codes with edit?
Thread Starter
On The Tree
Joined: Oct 2003
Posts: 169
Likes: 0
From: San Antonio, TX
can i pull codes with edit? i know if i program it will clear the codes...but i want to be able to see what codes the light is giving me...can i do that with ls1edit? i have edit but no logger.
thanks
thanks
Originally Posted by 02redSS
i know if i program it will clear the codes...but i want to be able to see what codes the light is giving me...can i do that with ls1edit? i have edit but no logger.
thanks
thanks
BowlingSS
Thread Starter
On The Tree
Joined: Oct 2003
Posts: 169
Likes: 0
From: San Antonio, TX
Originally Posted by Bill Bowling
How do you use LS1Edit without a logger?
BowlingSS
BowlingSS
and wouldn't you know, none of that stuff required a logger to accomplish correctly
Teching In
Joined: Apr 2003
Posts: 46
Likes: 0
From: Tucson, AZ
Originally Posted by 02redSS
well i set my part throttle shift points, my WOT shift points, my TC lockup points, set my TC to lock up at the top of 3rd at WOT, set my gear ratio, tire size, deleted torque management, deleted the rear o2 sensors, delete air pump codes, moved my rev limiter.
and wouldn't you know, none of that stuff required a logger to accomplish correctly
and wouldn't you know, none of that stuff required a logger to accomplish correctly
May I ask how you set your TC to lock at the top of third and how well it works. I was thinking of doing this to improve mph in the 1/4 mile. I would like mine to lock up and stay that way at say 95mph and up under full throttle.
Thank you.
Staging Lane
Joined: Feb 2004
Posts: 85
Likes: 0
From: San Antonio, TX
A4 TCC Tab - TCC MPH Threshold:
These values are for WOT operation. They indicate at what MPH the TCC will lockup and release in each gear. Make sure your release values are smaller than your apply values.
These values are for WOT operation. They indicate at what MPH the TCC will lockup and release in each gear. Make sure your release values are smaller than your apply values.
