2 step function with BS3 and a T56?????
#1
2 step function with BS3 and a T56?????
Looking for any help that can be offered using the 2 step in BS3 with my T56.
What I want will not be the typical or simple, but there has to be a way, and I am hoping some one has done it before.
What I want to have for function, is a 2 step that I can arm, and then floor it and then upon dropping the clutch it will be disabled till it is re-armed. So I want it to only be able to function once.
I do not want a push button on the shifter or steering wheel.
I want it for drag racing and I think it could be used for launching off the line at an autocross where I will be shifting up and down after the launch, so I do not want it reactivating if I go into 1st.
So I am thinking I will need a solenoid that can get a signal from my arming switch, then maybe be deactivated by a micro switch on the top of travel of the clutch. Not sure how this would wire up though.
Thanks in advance for your thoughts.
What I want will not be the typical or simple, but there has to be a way, and I am hoping some one has done it before.
What I want to have for function, is a 2 step that I can arm, and then floor it and then upon dropping the clutch it will be disabled till it is re-armed. So I want it to only be able to function once.
I do not want a push button on the shifter or steering wheel.
I want it for drag racing and I think it could be used for launching off the line at an autocross where I will be shifting up and down after the launch, so I do not want it reactivating if I go into 1st.
So I am thinking I will need a solenoid that can get a signal from my arming switch, then maybe be deactivated by a micro switch on the top of travel of the clutch. Not sure how this would wire up though.
Thanks in advance for your thoughts.