PCM Diagnostics & Tuning HP Tuners | Holley | Diablo
Sponsored by:
Sponsored by:

wont start, vats disabled

Thread Tools
 
Search this Thread
 
Old 05-14-2014, 06:00 PM
  #1  
Staging Lane
Thread Starter
 
00blackz71's Avatar
 
Join Date: Oct 2005
Location: Pontotoc, MS
Posts: 92
Likes: 0
Received 0 Likes on 0 Posts
Default wont start, vats disabled

Got an 03 GMC sierra that will spin over but wont start. Only code showing was a security code for no fuel P1626. I disabled the vats through hptuners and still wont start. It has 55-60psi while cranking and has spark at the plugs(only checked 3 plugs). Plug fires at the same time as compression hits. Wont hit a lick on starting fluid. With a test light the injectors show to be firing. Any ideas what to do next? Think it may still be a fuel problem but no idea where to start checking. Also the key is hard to turn sometimes. Does disabling vats in the tune not get rid of all the problems associated with it?
Old 05-15-2014, 12:32 AM
  #2  
TECH Addict
iTrader: (2)
 
gofastwclass's Avatar
 
Join Date: Aug 2009
Location: KCMO
Posts: 2,950
Received 26 Likes on 24 Posts

Default

Post the tune. You can also log in HP Tuners to see if VATS is actually disabled.

I believe there are some codes to disable but I can't remember which ones.
Old 05-15-2014, 06:58 AM
  #3  
Staging Lane
Thread Starter
 
00blackz71's Avatar
 
Join Date: Oct 2005
Location: Pontotoc, MS
Posts: 92
Likes: 0
Received 0 Likes on 0 Posts
Default

I'll have to wait till this afternoon to log and see what it says about the VATS status.
Attached Files
File Type: hpt
Shea Priest.hpt (494.5 KB, 121 views)
Old 05-15-2014, 04:50 PM
  #4  
Staging Lane
Thread Starter
 
00blackz71's Avatar
 
Join Date: Oct 2005
Location: Pontotoc, MS
Posts: 92
Likes: 0
Received 0 Likes on 0 Posts
Default

The VATS status shows pass so I assume its still not disabled for some reason. Am I missing something in the tune? Do I still need to do the resistor mod to the key switch?
Old 05-18-2014, 09:29 AM
  #5  
On The Tree
iTrader: (1)
 
dreww's Avatar
 
Join Date: Apr 2012
Location: burleson, tx
Posts: 184
Likes: 0
Received 1 Like on 1 Post
Default

if its vats related, the engine wouldn't crank at all.
Old 05-18-2014, 10:00 AM
  #6  
TECH Senior Member
iTrader: (25)
 
truckdoug's Avatar
 
Join Date: Nov 2013
Location: Portlandia
Posts: 6,330
Received 526 Likes on 356 Posts

Default

you got fuel pressure? pump should prime for a few seconds with the key in run, then turn off. should go back on after you crank it over.



Quick Reply: wont start, vats disabled



All times are GMT -5. The time now is 09:25 PM.