Torque by gear table???
Thread Starter
Teching In
Joined: Nov 2002
Posts: 41
Likes: 0
From: Melbourne, Australia
Torque by gear table??? Hey everyone,
I own a 99 Holden VT Commodore (LS1) with a 383 stroker (570fwhp)/Yank SS3800 stall/3.73 gears etc and when I was looking through my tune I noticed that in the torque by gear table all my values are set to 0. I thought that maybe I did this by mistake but when I looked back at the original tune it was set to 0 also.
I've looked at some other tunes from newer cars over here and they all have these values set at 640 which makes sense seeing that's the maximum torque figure that's allowed. My question is whether my table is incorrect and should read 640 and if this is the case what effects would having this table set to 0 have on my cars performance?
Any help is appreciated.
Brett.
I own a 99 Holden VT Commodore (LS1) with a 383 stroker (570fwhp)/Yank SS3800 stall/3.73 gears etc and when I was looking through my tune I noticed that in the torque by gear table all my values are set to 0. I thought that maybe I did this by mistake but when I looked back at the original tune it was set to 0 also.
I've looked at some other tunes from newer cars over here and they all have these values set at 640 which makes sense seeing that's the maximum torque figure that's allowed. My question is whether my table is incorrect and should read 640 and if this is the case what effects would having this table set to 0 have on my cars performance?
Any help is appreciated.
Brett.
