jimmyp

iTrader: (1)

I would like to run my oil pressure into my pcm so it can enter the serial data stream. I think the only way to do this is to run a corvette pcm and run the oil pressure wire into it. Besides the oil pressure input what else is different on the vette program that will conflict with my f-body harness/engine. Can it be done

thanks

P Mack

iTrader: (6)

The vette is drive by wire so you may have problems with the tps wiring and the iac won't work.

jimmyp

iTrader: (1)

good point.....how about if i was to switch to the vette tb setup

raven4960

iTrader: (1)

i'd be interested to know if you could put a drive by wire TB in an F-body...I would think that it would provide a little bit better throttle response

P Mack

iTrader: (6)

Well the wiring harness wouldn't be right for the drive by wire tb either.

raven4960

iTrader: (1)

How much of a PITA would it be to change that? Wiring harness + PCM + TB...Maybe cost would exceed the benefits??

jimmyp

iTrader: (1)

yea your right..kinda depressing cuz ive been wanting to run the vette cluster since day 1