Need Quick Advice!
#1
Need Quick Advice!
OK I am about to finish up my ve table and use reds spreadsheet and do my maf table. Do I need to wait until my LTFT are settled in before I input my maf numbers? I'm thinking this, correct me if I am wrong, finish STFT, leave sd mode, pe disabled, and LTFT disabled, and log for maf. Use spreadsheet for maf. insert maf reading and then enable everythinig. Also, in my tune my PE enrichment mutilplier is 1.250 across the board. Should I leave this or go back to stock values? Also my injector flow rate is not stock values? I have stock onjectors, should I leave these stock or with the tune in the car? I know that the car ran 12.8 timing on a dynojet and made 420 rwhp cam only. No KR or anything. Just curious if I should put the setting stock or use what I have. And NO I do not have wideband,.YET.........lol; I just dont wanna screw up a motor?
Dave
Dave