Pcm was locked out?
#1
LS1Tech Co-Founder
Thread Starter
iTrader: (34)
Pcm was locked out?
We went to tweak my existing program because my WOT A/F was 11.5:1, but it was locked out...
We subsequently started building a new program from scratch, but it takes a while when you are running 38 lb injectors like me.
The good new is that we are running like 31 degrees of timing and that was fine.
John
346ci - 350rwhp unlocked, 375rwhp locked
422ci - 419rwhp unlocked, 435rwhp locked
422ci - 445rwhp unlocked, ???
346ci - 390rwtq unlocked, 410rwtq locked
422ci - 430rwtq unlocked, 426rwtq locked
422ci - 501rwtq unlocked, ???
Hoping dyno #4 will go higher, we have more work to do... Not finished yet.
We subsequently started building a new program from scratch, but it takes a while when you are running 38 lb injectors like me.
The good new is that we are running like 31 degrees of timing and that was fine.
John
346ci - 350rwhp unlocked, 375rwhp locked
422ci - 419rwhp unlocked, 435rwhp locked
422ci - 445rwhp unlocked, ???
346ci - 390rwtq unlocked, 410rwtq locked
422ci - 430rwtq unlocked, 426rwtq locked
422ci - 501rwtq unlocked, ???
Hoping dyno #4 will go higher, we have more work to do... Not finished yet.
#3
LS1Tech Co-Founder
Thread Starter
iTrader: (34)
Re: Pcm was locked out?
I don't have any locked #'s yet.
We are in process of rebuilding the programming from scratch and are calibrating for my 38 lb injectors.
I am thinking 47_rwhp locked at some point.
We are in process of rebuilding the programming from scratch and are calibrating for my 38 lb injectors.
I am thinking 47_rwhp locked at some point.
#4
Re: Pcm was locked out?
Try this table... 58psi
KPA... 0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80
gm/sec 4.96 4.98 5.02 5.05 5.08 5.10 5.13 5.16 5.19 5.21 5.24 5.27 5.30 5.32 5.34 5.37 5.39
Best of luck!
John
[ March 10, 2002: Message edited by: John@PACE ]</p>
KPA... 0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80
gm/sec 4.96 4.98 5.02 5.05 5.08 5.10 5.13 5.16 5.19 5.21 5.24 5.27 5.30 5.32 5.34 5.37 5.39
Best of luck!
John
[ March 10, 2002: Message edited by: John@PACE ]</p>