motor stalling need help s10 with LS1
03-27-2002, 11:04 AM
#1
Staging Lane
Thread Starter
Join Date: Mar 2002
Location: Mansfield tx
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
motor stalling need help s10 with LS1 When I floor board the gas at low speeds my motor, acts likes something is holding the motor back for a fraction of a second, it does this several times for about a half of a second to a second. Then it’s fine.
The motor does not miss or there is no check engine light on. And it’s not the tach limiter. Does anyone know what causes this?
The motor does not miss or there is no check engine light on. And it’s not the tach limiter. Does anyone know what causes this?
03-27-2002, 02:58 PM
#2
LS1Tech Co-Founder
iTrader: (34)
Re: motor stalling need help s10 with LS1 I am going to move this to the HYBRID section.
If the car has no powwa down low and take forever to accelerate the TPS sensor might not be functioning properly
If the car has no powwa down low and take forever to accelerate the TPS sensor might not be functioning properly