Dip switch settings for MAFT and GMAF?
Thread Starter
Teching In
Joined: Jan 2002
Posts: 37
Likes: 0
From: Orlando, FL
Dip switch settings for MAFT and GMAF? If I am running a Granatelli MAF, do I need Dip Switch #4 on or off?
Also, I assume that #3 switch should be off unless I'm getting an error code.
The MAFT I have is version 5.2 BTW.
TIA.
Also, I assume that #3 switch should be off unless I'm getting an error code.
The MAFT I have is version 5.2 BTW.
TIA.
Re: Dip switch settings for MAFT and GMAF? I wish I had asked this before I installed the MAF-T with my Granatelli...I assummed it was an 85mm so I set the 4th dip switch to "on". The car ran like s#!t during PT and idle, but was fine at WOT. That is when I called an "expert" and found that you are not supposed to have the 4th switch on <img border="0" title="" alt="[Roll Eyes]" src="images/icons/rolleyes.gif" /> My question now is...did I screw up anything? It runs fine but now have a slapping noise at PT not under load.
I did try to push the car when it was running bad with the wrong setting.
I did try to push the car when it was running bad with the wrong setting.
