What do i have to change for HPT to read the GM 2 bar MAP right? I just went on a 30 minute drive and now pretty much all my data is useless. Under my MAP readings, it says Ive hit 160 kpa and 20 PSI in the charts... I really dont think that happened... but another chart says it maxes at 105kpa...

Also, why doesnt it save the Histograms when you save the log? If it does, I cant find them..

 

Dumb question, but did you activate the 2-bar part of the license?
It should have wanted a couple of credits...

 

160kpa is like 8psi off the top of my head.

 

per their unit conversion, its like 19 psi and also the Manifold air pressure scanner reading is pegging 20 psi...

 

yeah, thats done.

 

yeah but its PSI-atmosphere which is 14.7 if im not mistaken so if your seeing 20 psi its 20-14.7=5.3 actual boost.

 

ahhhhhh.. now that explains a lot! If Im only seeing 5 psi, then 5 psi pulls like a train Is there any way to simplify it so I dont have to subtract all the time?

 

That's good to know. Mine should be on the road in the next week or two, and I would have been up against this too.

 

make a custom pid map in psi minus 14.7

 

FOFF667

Is there a write up on doing that custome pid? I tried to do it once and gave up

not sure what I was doing