...well enough to get it on the trailer & to my tuner? It's a 98 SS stock bottom end, mild cam, D1SC at 7 psi. It's been tuned on the MAF but need to get this done. I have the GM MAP sensor # 12580698 to install & then will write the PCM to 2 bar in HPT v2.1.18,. Any guidance appreciated.

 

you'll need to at minimum setup a starter VE table as described in the flash demo within the help file. Depending on the cam you might need to even tweak that, idle, & spark. Then just unplug your maf & you should be good to go.

 

Thanks, I'll get that set up in a new .bin before I install the MAP sensor & flash the PCM before I try to run the car.