For those of you using Keyspan USB/Serial adaptor
05-06-2003, 12:57 PM
#1
Back in the staging lane
Thread Starter
iTrader: (3)
Join Date: Nov 2001
Location: NE Texas
Posts: 1,422
Likes: 0
Received 0 Likes
on
0 Posts
For those of you using Keyspan USB/Serial adaptor What model do you have and are there any specific settings you had to put it on to make it work with EFILive? Thanks.
05-07-2003, 05:22 PM
#3
TECH Fanatic
Join Date: Nov 2001
Location: Las Cruces, NM
Posts: 1,190
Likes: 0
Received 0 Likes
on
0 Posts
Re: For those of you using Keyspan USB/Serial adaptor I dont have eflive but mine works fine with autotap (well no so good, but thats autotaps fault) and ls1 edit. I have the 4 port version. Make sure you have the latest drivers from keyspan website. Mine would not work with anything with the drivers that came with it. Also set your interrupt and speed setting to "compatibility mode". This is slower (but still much faster than you need to log). Mine works in the high speed non-compatible mode.
Gary
Gary
05-08-2003, 11:26 PM
#4
Back in the staging lane
Thread Starter
iTrader: (3)
Join Date: Nov 2001
Location: NE Texas
Posts: 1,422
Likes: 0
Received 0 Likes
on
0 Posts
Re: For those of you using Keyspan USB/Serial adaptor I have just the single port version. I think it's like 19QW or something. Anyone have that one?
05-09-2003, 08:49 AM
#5
TECH Fanatic
Join Date: Nov 2001
Location: Las Cruces, NM
Posts: 1,190
Likes: 0
Received 0 Likes
on
0 Posts
Re: For those of you using Keyspan USB/Serial adaptor They all use the same hardware and software drivers. You might also check some of your other settings on the usb.
Gary
Gary
05-09-2003, 07:23 PM
#6
Back in the staging lane
Thread Starter
iTrader: (3)
Join Date: Nov 2001
Location: NE Texas
Posts: 1,422
Likes: 0
Received 0 Likes
on
0 Posts
Re: For those of you using Keyspan USB/Serial adaptor That's what I need to know. Do you have to change anything on the Keyspan settings and if so, what are they?
