Is It Possible?
Thread Starter
TECH Fanatic
iTrader: (147)
Joined: Feb 2003
Posts: 1,067
Likes: 1
From: Tullahoma,Tn
Is It Possible? To mix up the cam sensor and the map sensor plugs in the back on the motor? becouse I just did a motor swap and when I try to start it it just dumps gas and fauls the plugs..I kinda blamed it on my tuner becouse I went from 26# to 42# I was thinking he might not have scaled my injectors right..the car is also throwing a mult. misfire code
Last edited by Ego Killer; Sep 16, 2007 at 11:11 PM.
Get a dyno tune!!! Your new setup is way more radical than your old one. But the mail order tune should have taken care of the injector part (those are easy to scale). But if some other table(s) is out of whack, you will still run pig rich. Don't know about the multi misfire though. Probably just the huge cam and stuff screwing with the computer. Make sure everything is plugged in (grounds too) and put some new plugs in it. Then get ready to send the computer off a few more times.
