MAF Translator ?
06-16-2003, 02:30 PM
#1
On The Tree
Thread Starter
iTrader: (4)
Join Date: Jan 2003
Location: New York
Posts: 100
Likes: 0
Received 0 Likes
on
0 Posts
MAF Translator ? I am using AutoTao and MAFT on a 00 Camaro SS...
Is each subsequent MAFT BASE percentage based on the original (nonMAFT) factory settings or the previous average.
In other words do I calculate my next adjustment based on the previous average or the value obtained at MAFT=0?
Same question with the WOT settings.
Thank you,
Scott
Is each subsequent MAFT BASE percentage based on the original (nonMAFT) factory settings or the previous average.
In other words do I calculate my next adjustment based on the previous average or the value obtained at MAFT=0?
Same question with the WOT settings.
Thank you,
Scott
06-16-2003, 03:14 PM
#2
Launching!
iTrader: (4)
Join Date: Nov 2001
Location: St. Peters Missouri
Posts: 250
Likes: 0
Received 0 Likes
on
0 Posts
Re: MAF Translator ? If you used atap and then adjusted it and it still wasnt right then you would atap it again and adjust it from where ever it was when you used atap.
06-16-2003, 07:45 PM
#3
TECH Enthusiast
Join Date: Jan 2003
Location: Birmingham, AL
Posts: 582
Likes: 0
Received 0 Likes
on
0 Posts
Re: MAF Translator ? I'm not understanding your question completely, but you adjust your BASE until your LTRIMS are negative. Adjust 5% and if that doesnt fix it, adjust 5 more percent. Continue doing this until your LTRIMS are right where they should be.
