Connecting 3 bar MAP to TBSS harness.
Thread Starter
Staging Lane
Joined: Apr 2004
Posts: 79
Likes: 0
Connecting 3 bar MAP to TBSS harness. I am making a 3-pin weatherpack to 3-pin metripack adapter/harness so that It will connect my car's map sensor wire(s) to the 3-bar sensor (no need for wire cutting). So what I need is a replication of the LS2 1-bar MAP connector... male pins.. female connector. Hard to describe. Am I correct in my guess of the metripack connector? If so, which type is it? The GT or the 150?
Ok.. its always when I ask a question that I end up answering it.
http://connectors2.delphi.com/DCSGDM...rtNum=12129615
Bing..
and
http://connectors2.delphi.com/DCSGDM...rtNum=12129946
Its female counterpart.. found on the LS2 wiring harness.
Lots of info on that site!! Chime in if I am headed in the wrong direction. Now.. heres another closely related question. In HPT, how do I go about using a 3-bar sensor with an OS that has a limit of 256kPa in the sensor configuration/calibration menu?
Ok.. its always when I ask a question that I end up answering it.
http://connectors2.delphi.com/DCSGDM...rtNum=12129615
Bing..
and
http://connectors2.delphi.com/DCSGDM...rtNum=12129946
Its female counterpart.. found on the LS2 wiring harness.
Lots of info on that site!! Chime in if I am headed in the wrong direction. Now.. heres another closely related question. In HPT, how do I go about using a 3-bar sensor with an OS that has a limit of 256kPa in the sensor configuration/calibration menu?
