P0106....Manifold Absolute Pressure/Barometric Pressure Circuit Range/Performance Problem

How do I fix this? I cleared the code once already and it came back. I just put in a cam so maybe that's why? I'm also pulling one of the heads because I broke a header bolt inside. Should I look for anything while I'm doing this? Should I replace the MAP Sensor?

Cam is a TSP 233/239. Also put in a new timing chain, oil pump, valve spring set, and push rods.

 

vaccume leak?
also check this thread p0106

 

have you gotten a tune yet?

 

Not yet.

 

its either a vac. leak or your idle is low.raise your idle to about 850-900rpm.

 

Any cam bigger than about a 224 needs the min and max values for the P0106 diagnostic raised in the calibration.

 

So it's really no big deal. I just need to get my car tuned?

 

I had the same problem after cam. Needs changes in tune to correct.

Bill