How to properly correct a wb A/F pid in hptuners?
05-08-2008, 02:48 AM
#1
11 Second Club
Thread Starter
iTrader: (14)
Join Date: Nov 2004
Location: Michigan (Macomb or Lansing)
Posts: 1,653
Likes: 0
Received 0 Likes
on
0 Posts
How to properly correct a wb A/F pid in hptuners? I have my lc-1 working similar to this:
https://ls1tech.com/forums/showthrea...ht=eio+without
I use my egr instead.
I use the pid given there:
(Voltage / .625 ) + 10
the way it is derived is correct. I am thinking there is a slight difference in the wideband's digital readout and the onein hptuners,
Is there anyway i can correct the formula to make them the same?
https://ls1tech.com/forums/showthrea...ht=eio+without
I use my egr instead.
I use the pid given there:
(Voltage / .625 ) + 10
the way it is derived is correct. I am thinking there is a slight difference in the wideband's digital readout and the onein hptuners,
Is there anyway i can correct the formula to make them the same?
05-08-2008, 08:05 AM
#2
12 Second Club
iTrader: (8)
Join Date: Jul 2004
Location: Vancouver, BC
Posts: 708
Likes: 0
Received 0 Likes
on
0 Posts
I just adjusted my denominator to make it match as close as possible to Logworks.
Somewhere sometime my logic determined that was the way to go, not sure if its right.
Somewhere sometime my logic determined that was the way to go, not sure if its right.
05-08-2008, 03:48 PM
#4
Teching In
Join Date: Nov 2003
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
