Post pics of your engine bay
#21
12 Second Club
iTrader: (3)
Join Date: Apr 2004
Location: Grand Rapids, Michigan
Posts: 1,512
Likes: 0
Received 2 Likes
on
2 Posts
I would post if I had a Svede, but my Vararam looks crappy. Since I see a lot of VR and Svede's in here, I have a quick thread jack question. I removed my radiator shroud and tossed it (did not cut it well). Is this hurting flow to my VR filter? I can't wait to get a Svede.
#23
12 Second Club
Join Date: Mar 2012
Location: Fort Wayne IN
Posts: 355
Likes: 0
Received 0 Likes
on
0 Posts
#31
TECH Apprentice
Join Date: Dec 2006
Location: Marble Falls, TX
Posts: 311
Likes: 0
Received 0 Likes
on
0 Posts
Here's a pic of when I was installing my new OTRCAI. For some reason I didn't take a pic of it fully installed. In this pic we were test fitting and trimming the fan shroud.
#37
12 Second Club
iTrader: (3)
Join Date: Apr 2004
Location: Grand Rapids, Michigan
Posts: 1,512
Likes: 0
Received 2 Likes
on
2 Posts
I did too. A lot of people said the paint wouldn't hold up from the heat. I used Rustoleum "Universal" paint for all surfaces and it was primer and paint all in one. It's been really hot here like everywhere else and it's holding up fine.