I just got back from American Racing Headers with some awesome headers. I went with 1 7/8" headers and catted connection pipes. I watched the whole install and the is plenty of room between the headers and the steering shaft. I was able to put atleast one finger around the steering shaft, all the way around. There is also tons of room between the headers and the steering rack. I want to thank Nick at American Racing Headers and Carmen from the Vette Doctors. Between them two, I ended up with 371/375 with a full exhaust intake and tune. My original number with only the Lingenfelter CAI and SLP catback was 344/342. So I picked up about 27/32. Ill post a ton of pics from the install as well as a scan of the dyno sheet. If you need a set of headers, I highly recommend American Racing Headers because of there superb quality, fitment and power. :burnout: :burnout: :burnout:

The day started off with a few dyno passes. I ended up making 344/342


After the dyno, the car went inside American Racing Headers for a set of 1 7/8" headers


The stock exhaust was removed and the headers were installed




I found some crimps in the stock exhaust when I was looking at it on the floor.



Its hard to see in these pictures but there is plenty of clearance between the headers and steering shaft. The headers clear the steering rack by a long ways. Its as good as it will get with any design.

 

Here are a few finished pictures










The Dyno sheet. This has the pre-header, after headers, and after headers and tune.


And a few other goodies I saw while I was there.



All in all it was a fun day. I cant wait to get this bad boy to the track.

 

that's awesome. congrats

 

damn thats a nice set of headers

Almost as nice as my ARH`s