When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
We decided to clean our nitrous filter from our pump station, after filling bottles for two months. This is what came out of it. This is trash from the mother bottles. Lets face it, a lot of these mother bottles are old. There is bits and pieces of Teflon tape, rust and small pieces of trash.All of these contaminants can end up in your system. Something as small as a grain of sand can cause a nitrous solenoid to be jammed open and leak. If the place that is filling your bottles doesn't have a filter, this can be going into your bottles. Hopefully this can show you the importance of having a nitrous filter.
We usually run the filter by the bottle. Use the short line from the bottle to filter and then connect your main feed to the filter. An affordable filter can save you a lot of headache later down the road. - Matt
Last edited by Nitro Dave's Nitrous Outlet; 04-13-2016 at 10:43 AM.
No you wont have any issues at all. There is a phase change as it expands into the filter but its so small that you will never notice it. We have a customer spraying an 800 shot using a filter with no issues at all.
Last edited by Nitro Dave's Nitrous Outlet; 04-14-2016 at 09:17 AM.
We usually run the filter by the bottle. Use the short line from the bottle to filter and then connect your main feed to the filter. An affordable filter can save you a lot of headache later down the road. - Matt
OK good deal. My wife bought me a filter from yall I just haven't got around to putting it in yet.
I noticed a huge change in the crap in my filter when I changed vendors... Old vendor did not use dip tubes in the mother bottles.... Had a ton of crap. New vendor has dip tubes, less crap but lose more in the mother bottle
Any pictures of the filters set up? I was thinking about looming my two bottles together that are going to be mounted on the hump and have the filter right after. Figured it was better than having the filter in the engine bay