Motor pulled
#1
Teching In
Thread Starter
iTrader: (4)
Join Date: Jan 2015
Location: Milford mi
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
Motor pulled
Just pulled engine and trans from out the bottom of my, now I'm trying to get the engine off and trans off of the k member, I unbolted the four small bolts to the motor mounts when I try lifting the motor k member staying with it? Thanks
#4
11 Second Club
iTrader: (3)
Join Date: Apr 2014
Location: St Louis, MO.
Posts: 624
Likes: 0
Received 0 Likes
on
0 Posts
Two long bolts, one through each motor mount and it'll come right out. May need a little persuasion if it's been in there a while, but that's all that is holding it on. If you look, you can see the holes on both sides when I pulled mine.
#5
Teching In
Thread Starter
iTrader: (4)
Join Date: Jan 2015
Location: Milford mi
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
[QUOTE=Deeohgie69;19230522]This^^^
Two long bolts, one through each motor mount and it'll come right out. May need a little persuasion if it's been in there a while, but that's all that is holding it on. If you look, you can see the holes on both sides when I pulled mine.
[/
Thanks guys it was the two bolts
Two long bolts, one through each motor mount and it'll come right out. May need a little persuasion if it's been in there a while, but that's all that is holding it on. If you look, you can see the holes on both sides when I pulled mine.
[/
Thanks guys it was the two bolts
Trending Topics
#8
11 Second Club
iTrader: (3)
Join Date: Apr 2014
Location: St Louis, MO.
Posts: 624
Likes: 0
Received 0 Likes
on
0 Posts
Funny thing about mine is, that I had to do mine to change my kmember and send my transmission off to be built. I had my motor in place with a 2x6 across my strut towers with a chain & jack below while we swapped the kmember out. Worked though, so that's all I cared about... but I was worried while we did it lol
#9
Teching In
Thread Starter
iTrader: (4)
Join Date: Jan 2015
Location: Milford mi
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
That's crazy, glad you and your motor are okay lol
Funny thing about mine is, that I had to do mine to change my kmember and send my transmission off to be built. I had my motor in place with a 2x6 across my strut towers with a chain & jack below while we swapped the kmember out. Worked though, so that's all I cared about... but I was worried while we did it lol