When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
So i sent on3 a couple of pics as they requested.
And this is what i got
I mean im not a turbo expert, but how would slag create in and out shaft play.
And to say that you cant see where the compressor wheel hit the housing is just funny.
Put a peak and hold tire pressure gauge (3$) pre and post IC and make a pull. My IAT's were fine with my $120 china IC, but the pressure drop across the core was bad.
FWIW you can grab some SS safety wire from harbor junk super cheap and it works great at keeping that heat wrap in place. .030 or smaller works best IMO. Some HF safety wire pliers make installing a bit easier. Then hose it down good with BBQ grill paint and it makes the wrap more rigid, almost like glue. Doesn't move at all if you wrap it careful.
Last edited by Forcefed86; 04-25-2016 at 09:45 AM.