When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Just a quick question, I bought a stage 2 spec clutch wanted to know if I had the throw out bearing installed to the clutch correctly with the retaining clip holding it in place? Second question is the pilot bearing is not really greased that much. Do I apply more; and what type of grease? And what does everyone put for grease on the input shaft?
Cleaned it up pretty good it had grease when cleaned.
TOB is fine and if the bearing was greased then I'd leave it alone. You don't wanna pack too much in there or you risk it ruining the clutch disc. You can also rub a very very very small amount of grease on the input shaft splines where the disc touches.