blacknyellow

iTrader: (3)

Hey guys I got a good deal on a truck mp112 kit that is designed for the 4.8 5.3 and 6.0 trucks. I have a ls1 with c5 belt routing, no a/c in my s10. The blower is spaced for the truck belt alignment and I was wondering if anyone has made the truck mp112

fit to the corvette/camaro/trans am system. I am not asking about belt routing, simply the offset between the truck belt and the car belt system.
Maybe magnusun can chime in.
Does anyone make a pulley for the mp112 snout that mounts in the same spot but is offset rearward to align with the car pulleys? Different snout?
i'd like to avoid changing to truck crank pulley/ps pump/alternator brackets if at all possible.
thanks a lot guys

jimmyg

Use a truck balancer and the 11/2 spacer designed for the Holley front drive. The corvette alt/ps bracket and the Holley are almost identical. I have done this and it works perfect.

jimmyg

Truck balancer is around $100, spacer kit $59 you might also need a water pump . I used 2010 Camaro. If you have the large bell type wp pulley you might be fine