Category: Engine - Power Adders
Price: $2500
Location (State): MI
Item Condition: Brand New
Shipping Information: Item Can be Shipped
Engine: LS2/LS3/LS7/L92/LS9, LS1/LS6
LS Engine?: Fits LS Engine

Looking to sell this all as a set. I was in the middle of doing a twin 66mm on my 67 Camaro with a lsx, but ended up going with a different route and I have all this stuff left over.

2 - Turbonetics 6665-4 Lety 76mm turbo's with custom ordered .68 exhaust a/r housings. Was for a street 6.0L LS engine and a target of 1,000 horsepower. Comes with AN oil drain fittings and custom mounting brackets for a first generation camaro. https://turboneticsinc.com/store/ind...&product_id=80

2 - K&N cone air filters for above turbo's

2 - 1.75 double slip collectors in 304 stainless and a 3" vibrand v band flange (ordered from stainlessheaders.com). I paid $350 each for these

1 - Bag of collector locking tabs

10 - 1.75" 304 stainless J bends from stainlessheaders.com. One is cut in half

2 - 3/8 stainless high quality 304 Chevy LS engine flanges from stainlessheaders.com

2 - 304 stainless t4 flange to vibrant v band flange on a 3" bend radius

1 - 24x16x3.5 Intercooler with twin inlets & 1 outlet

$2500 for all.

 

pm'd you

 

Pm'd you

 

I was able to dig up the receipt of what I paid just the header components.

I'm surprised I still have this all at this price.

 

Great price
awesome set up
wish i had the cash, just bought my ERL block.

 

bump.

 

Where are the mounting brackets designed to mount the turbos a 1st gen Camaro?

 

 

So are the headers already built?

 

It is all the components to build the headers.

 

I see now I was looking at it last night on my phone and it looked like they were already complete on the smaller screen. Have you already build mounting brackets for the intercooler.

 

I just used a piece of square aluminum tube with holes drilled through the rad support. It mounted very easy...I can't seem to find the pieces though!

 

Are both of these bends included?

 

If you look at the pictures in the first post that is everything you will be purchasing at the price above.

If you would like those bends I can include the picture below for an extra $200. Just so you know that is a custom tight radius bend mandrel 304SS tube with SS vibrand 3" vband flanges. The flanges alone cost $75 each and there are 4 of them

 

This would be awsome for my 69 Camaro w LS3. Free bump.

 

bump.

 

Convincing the wife! Bump

 

Sold!