Need advice- LS swap Obs
#1
Need advice- LS swap Obs
Can anyone tell me where I should weld in this pressure transducer on my ac? It's suppose to cycle my compressor and control the fans also. I was told weld into "high side" line. Truck is a 98 k1500 with a 05 5.3, BP harness.
#2
TECH Senior Member
They mean the high pressure line. Can't make it clearer than that.....
#3
Well THIS is why I'm asking, which one is the high pressure line?!? There is a high pressure discharge line from compressor to condenser, THEN there is the liquid line from condenser to evaporator.. And where is the best location on said line?? Pretty clear question🤷
The following users liked this post:
G Atsma (04-29-2024)
The following users liked this post:
Lit549 (04-29-2024)