Ls3 softer style engine mounts
#1
On The Tree
Thread Starter
Ls3 softer style engine mounts
Hey,
It's been a long time away from the forum, I am looking for some advice with my engine swap. I have stock GTO?? engine mounts and was looking for something that might do a better job absorbing vibration.
Any ideas??
It's been a long time away from the forum, I am looking for some advice with my engine swap. I have stock GTO?? engine mounts and was looking for something that might do a better job absorbing vibration.
Any ideas??
#2
TECH Senior Member
Unless you have a nasty-loping cam, there should be no vibration.
Are you getting too much vibration, or too much movement??
Are you getting too much vibration, or too much movement??
The following users liked this post:
G Atsma (08-14-2024)
#4
On The Tree
Thread Starter
YOU KNOW this is going to sound a real lame, but I don't remember just what ls mounts I have. They are factory ones, but I didn't think they were oil filled. I will snap a picture and post it tomorrow. I got a set of Hinson mounts, but they feel verry hard??? Haven't installed them as yet ...
#5
On The Tree
Thread Starter
My question is this a Camero / GTO engine mount ???????????????
This is a picture of my mount ??
This is a picture of my mount ??
Last edited by driveability; 08-19-2024 at 01:42 AM. Reason: information
#6
On The Tree
Thread Starter
SO, I did find my mounts were oil filled and leaking, I Think they failed because I jack up the drivetrain when replacing the clutch. At this point I don't often hammer the throttle LOL At 69 years old explaining a smoke show to a cop would be strange and expensive LOL.